1. Hello Guest,

    VapingBlips.com is a social community of vapers gathering to discuss all things vaping and life in general. We have contests, play games, babble about nonsense and even share useful info about vape gear, e-liquids and DIY info.

    We have no interest in spammers or trolls and our members have tools that allow them to remove offending posts if enough members rate it as spam or trolling.

    We hope you like what you see and decide to register and join us.

    If you have any questions, feel free to send an e-mail to [email protected] and we hope to see you soon ;)

Maxus 200W Kit Review

Discussion in 'Hardware and Accessories' started by Blue1, Jul 12, 2020.

  1. Blue1

    Blue1 Blip Charm Vendor

    https://www.freemaxvape.com/maxus-200w-kit/

    I received this for review from Tina @ Freemax… Thank you Tina

    Maxus ProTank Resin Edition:
    I love the feel and the look of this tank on top… the Diamond beveled glass is so pretty in the sun… mine has a tint of pink in it, but that’s either from my cotton candy juice or the orange O-rings. There is matching colored resin on both the top & bottom of the tank and a matching 810 drip tip makes it look so classy!….… The coils are great with the little shelf to keep you from running dry Part of the M Pro 2 series…The kit comes with 2 coils, .15 & .20 ohm. The .20 ohm comes pre installed so that’s the one I am still using 2 weeks later...

    Maxus 200 W Mod:
    The battery door is the side with the design on it, no rattle with 2 strong magnets..… mine is the blue and I love it… it’s the resin swirls that make it look so classy….and also helps to keep it from sliding out of your hand…..I love the Type C charging port… I rarely use them but that’s the one I use for my phone so there is always one around….It supports single batter load… so when you are swapping out batteries it comes on as soon as you get 1 inserted(80w)...It also says no polarity… so it doesn’t matter how you put them in.. but I usually do it the same way I do all my other dual 18650’s, although I did try it to see how it works and any way you put the batteries in it works & reads 200w.......

    Easy to use menu, 3 clicks and it brings up all the functions. There is VPC, Bypass, TC,TI, SS, NI.4 TC memory.
    You can set your Timeout, test coil, puff counter, time used, C/F & reset...
    You can check the power in each battery, the version & temp.
    The OLED screen shows everything you need(not colored)

    Pros:
    Lots of protection, Single battery, Any battery configuration, comfortable fit, Classy looking matchy matchy, the 5 ml tank last me almost all day….

    Cons:
    I wish the filling hole was just a little bigger… I had an air bubble back out a lot of juice on more than one occasion…..

    Parameters
    Tank Capacity: 5ml//2ml (TPD)
    Battery: 18650*2
    Charger Specification: 5V/2A
    Resistance Range: 0.1-3ohm
    Input Voltage: 3.3-4.2V (Single battery) / 6.6-8.4V (Dual battery)
    Output Voltage: 0.7-8.4V
    Output Wattage: 5-200W/100-315℃/200-600℉
    Output Mode: Power/VPC/Bypass/TC-TI/TC-SS/TC-NI/TCR

    In The Box
    1*Freemax Maxus 200W VW Mod
    1*Freemax MPro 2 Tank Resin Edition (Freemax 904L M2 Mesh Coil 0.2ohm)
    1*Extra Freemax 904L M1 Mesh Coil 0.15ohm
    1*Extra Glass Tube 5ml (Individual packaging of extra glass for TPD edition)
    1*Extra O-ring
    1*Type-C USB Cable
    1*Warning Card
    1*Warranty Card
    1*User Manual

    [​IMG][​IMG][​IMG][​IMG][​IMG][​IMG]