Ask TheWestPole

Discussion in 'Regulated Mods' started by InMyImage, Jun 23, 2015.

  1. InMyImage

    InMyImage Geeky blip :) Staff Member

    @TheWestPole I have a question that I'm hoping you can answer as our resident mod and atomizer customizer extraordinaire...
     
  2. InMyImage

    InMyImage Geeky blip :) Staff Member

    @TheWestPole
    So... I think I've just about done in the 510 connector on my Cloupor T8 and frankly would really like a spring loaded 510 anyway because Cloupor's 510 actually screws in as you tighten the atty, meaning that as you tighten the atty down, down goes the 510 so the next time you switch it out, it gets closer and close to the bottom :rolleyes:

    So any advice on how to replace the 510 connector?
     
    Last edited: Jun 23, 2015
  3. TheWestPole

    TheWestPole A hit on Mr. Mitty

    I couldn't tell you without seeing the mod taken apart and a few measurements. You need about 13mm inside the case to clear the spring loaded connector, wiring, fastener, etc. I've reduced that a little but not much.

    If you don't want to dismantle yours, maybe you could find pics online by somebody who has.
     
  4. TheWestPole

    TheWestPole A hit on Mr. Mitty

    Don't you dare! :p Please delete. I always answer questions related to stuff I post, and advise anybody who seeks me out, but I don't want to offer a general service.
     
  5. InMyImage

    InMyImage Geeky blip :) Staff Member

    LOL, ok, I'll go clean up :oops:
     
  6. muth

    muth More than a poop!

    Aw pishh, wouldn't it be great to have The West Pole at our beckon call:p?
     
  7. InMyImage

    InMyImage Geeky blip :) Staff Member

    I think he said he would be, just doesn't want an official thread for it ;)